Chapter 12 Education
Notice Tuesday, June 12,
2007
Die Coating and Surface Treatments
Chapter 12 is offering the following
new course. This course will be held in the at Klemmers Banquet Center in
the Federal Room. The classes will start at 8:30AM, finish approximately
3:30 PM.
A one-day course focused on the
fundamental principles of coatings and surface treatments for die casting dies
as well as repair and removal techniques. This course is designed to
provide a basic understanding of various coatings applicable to die components
by covering topical areas such as coating processes, structure, properties,
application, and characterization and evaluation of coatings. Current
state-of-the-art commercial and experimental coatings are presented and methods
for optimizing coating architecture are addressed.
This course will be presented by Prof.
John J. Moore, of the Advanced Coating and Surface Treatment Laboratory,
Colorado School of Mines, at Golden, Colorado.
The cost of this class is $195.
The cost includes a continental breakfast, lunch and all materials. If
you attended any of the Process Control mini-courses this year, your cost will
be $150.
This course is targeted to all persons
responsible for tooling, toolmaker to the DC engineer. This course should
help in identifying coating candidates to solve die casting
problems.
Reservations on-line at
henry.bakemeyer@sbcglobal.net
or call Henry @ 414-456-9456
or fax @
414-259-9912
Meeting Location:
Klemmer’s
Banquet Center 414-541-0401
10401 W. Oklahoma Avenue,
Milwaukee
From
Downtown: From the
Airport:
Take I-94 West to I-894
South Take I-94 North to I-894 West (Madison &
Fond du Lac)
Take I-894 South to the Oklahoma Avenue
exit Go to Exit #3 (Beloit Road)
At the end of the ramp, turn
right At the end of the ramp turn
right
Klemmer’s Banquet Center is 1½
blocks west of the exit At the first stop light (100th
Street) turn left
At the next stop light (Oklahoma Avenue) turn
left
Klemmer’s Banquet Center is 4 blocks west of
100th Street
